Mark COLDSTREAM Technisches Handbuch Seite 4

1.4 Foreseen use
The ColdStream evaporative cooler can be installed in all environments where it is necessary to
improve the microclimate, where the environment must be ventilated with frequent changes of
fresh, filtered and possibly cool air, such as:
• production buildings and units;
• sales areas and warehouses;
• sport areas such as gymnasiums.
It is absolutely forbidden to make modifications to the machine and its destination of use.
The supplier declines all responsibility for any damages which may be, directly or indirectly, caused
!
to exposed persons or property, due to improper use or use of the machine for different purposes
other than the design purposes, incorrect installation, inappropriate power supply, different or
changes to the installation environment from the one declared during order confirmation, grave
deficiency of maintenance, unauthorized alterations and modifications, use of non-original spare
parts, removal of the protection guards, inobservance of the instructions for use, negligence, etc..
The machine must NOT be used for a different use than its designed use for any reason
whatsoever or used in a different way than stated in this manual.
DO NOT install the machine in closed areas; the machine must be installed outside the area to be
treated, except by specific approval of the manufacturer.
Do NOT start-up the machine if it is not connected to the relative plant (duct) of air distribution.
When the plant is operating, do not touch the fan – Mechanical danger.
It is forbidden to work on moving parts.
It is absolutely forbidden to install ColdStream evaporative cooling plants in potentially explosive
environments.
1.5 Machine identification data
Machine identification data is shown on the warranty sheet supplied to the customer and is
enclosed in the documentation and on the machine identification plate.
If Technical Assistance or spare parts are required, always supply the machine model and serial
!
number.
1.6 Electrical boards
Any electrical boards supplied by Mark Climate Technology. are manufactured according to EN
60204/1 regulations.
It is absolutely forbidden to make modifications to the electrical board.
4