Mark COLDSTREAM Technisches Handbuch Seite 17

6.2.5.6 Setting temperature and humidity values
Default factory settings:
Keep pressed the
the set point value and the
Use the keys to increase or decrease the value.
To confirm press the
Keep pressed the
the set point value and the
Use the keys to increase or decrease the value.
To confirm press the
6.2.5.7 Locking/Unlocking remote control unit
It is possible to lock the remote control unit to avoid the control by anyone.
To lock the remote command unit the HL parameter value must be modified from NO to YES.
Modify the HL parameter as follows:
• Keep pressed together the
• Press the key twice.
• Press the or
• Press the key to see the current setted value.
• Press the or
• Press the key again to go back.
To save the modification and exit press the
When the remote control is locked, display shows Loc when pressing every key. To temporary
unlock the remote control, keep the
control goes automatically back to locked status after 15"sec. from last key pressing.
Temperature : 26°C
Relative humidity : 75%
key until "SP" is displayed (then release the key). The display shows
symbol blinking.
key or wait 10"sec.
key until "SP " is displayed ( then release the key). The display shows
symbol blinking.
key or wait 10"sec.
keys more than 2"sec until the display shows PA.
keys to find the parameter to be changed. In this case choose HL.
keys to change the value.
key pressed until the display shows off. The remote
key or wait 30"sec.
EN
17