Mounting On False Ceiling; Connection To Mains; Connection To Programming Unit - Kindermann compact2 80 Installations- Und Bedienungsanleitung

3.5 Mounting on false ceiling

If the ceiling lift is not mounted directly on a real ceiling the extension set with stabilizers is needed (7466000019).
To guarantee a sturdy construction additional props may be necessary.
Attention: Before mounting the extension set the two stabilzers
!

4. Connection to mains

The motor of the ceiling lift is a reversal single phase condensor motor, similar to the ones used for shutters, with integrated
electronic stop switches, brake and transmission.
Connection the unit to the mains must only be done by an electrician. Never use damaged devices. Before mounting
!
the lift check the specifications on the lable with thoses of the local power supply. Do all mounting and maintenance works
with the power supply switched of.
The projector is connected to the mains via the provided wiring through the spiral cable guide
projector garage.
zur Schalterdose und schließen Sie es zunächst an die Programmiereinheit nach

4.1 Connection to programming unit

3a
to the socket and connect the programming unit according to the following circuit diagram.
3a
Guide the 4-pin motor cable
Circuit diagram programming unit
Mains
PE N L
Switch for projetor
Schalter zur
Switch for
Seilspannungsüberwachung
control of safety rope
blau
schwarz
braun
gelb/grün
Projector
Ceiling lift
Anschlussdose
Deckenlift
24
a
a
to the socket and connect the programming unit according to the following circuit diagram.
3a
Netz
blau
blue
blue
black
schwarz
black
brown
braun
Programmiereinheit
7466 000 100
yellow/green yellow/green
gelb/grün
Power socket
ceiling lift
a
on the upper frame of the lift.
a
a on the upper frame of the lift.
an der
5a
Mains
brown
Programming unit
Programming unit
7466 000 100
7466 000102
am
to the mains socket of the
5a
to the mains socket of the
5a
9
25