Packaging; Starting, Operation - WIKA E-10 Betriebsanleitung

5. For your safety / 6. Packaging / 7. Starting, operation
Consider the details given in the EC-type examination certificate as well
as the respective specifications for explosion hazard use of the country
concerned (e.g.: IEC 60079-14). If you do not observe these stipulations,
Warning
serious injuries and/or damage can occur.

. Packaging

Has everything been supplied?
Check the scope of supply:
Completely assembled pressure transmitters; with flush version E-11 including pre-

assembled sealings and protection cap.
Inspect the pressure transmitter for possible damage during transportation. Should

there be any obvious damage, inform the transport company and WIKA without delay.
Keep the packaging, as it offers optimal protection during transportation (e.g. chan-

ging installation location, shipment for repair).
Ensure that the pressure connection thread and the connection contacts will not be

damaged.
In order to protect the diaphragm, the pressure connection of the instrument E-11 is provided
with a special protection cap.
Remove this protection cap only just before installing the pressure transmitter in order

to prevent any damage to the diaphragm or the thread.
Keep the protection cap of the pressure connection thread and the diaphragm for

later storage or transport.
Mount the protection cap when removing and transporting the instrument.


7. Starting, operation

Required tools: wrench (flats 27), screw driver

WIKA Operating instructions/Betriebsanleitung E-10, E-11
GB