Important Details For Your Information - WIKA E-10 Betriebsanleitung

1. Important details for your information

1. Important details for your information
Read these operating instructions before installing and starting the pressure transmitter. Keep
the operating instructions in a place that is accessible to all users at any time.
The following installation and operating instructions have been compiled by us with great care
but it is not feasible to take all possible applications into consideration. These installation and
operation instructions should meet the needs of most pressure measurement applications. If
questions remain regarding a specific application, you can obtain further information:
Via our Internet address www.wika.de / www.wika.com

The product data sheet is designated as PE 81.27

Contact WIKA for additional technical support (+49) 9372 / 132-295

If the serial number and/or the 2D code on the hexagon gets illegible (e.g. by mechanical
damage or repainting), the retraceability of the instrument is not possible any more.
WIKA pressure transmitters are carefully designed and manufactured using state-of-the-art
technology. Every component undergoes strict quality and environmental inspection before
assembly and each instrument is fully tested prior to shipment. Our environmental manage-
ment system is certified to DIN EN ISO 14001.
Use of the product in accordance with the intended use E-10, E-11:
Use the flameproof pressure transmitter to transform the pressure into an electrical signal in
hazardous areas.
Certificate ATEX:
Pressure transmitter for operation in hazardous areas in compliance with the respective certifi-
cate (see EC-type examination certificate KEMA 05 ATEX 2240 X).
ATEX Approval ratings: Flameproof for II 2G Ex d II C
Knowledge required
Install and start the pressure transmitter only if you are familiar with the relevant regulations
and directives of your country and if you have the qualification required. You have to be
acquainted with the rules and regulations on hazardous areas, measurement and control
technology and electric circuits, since this pressure transmitter is „electrical equipment" as
defined by EN 50178. Depending on the operating conditions of your application you have to
have the corresponding knowledge, e.g. of aggressive media.
WIKA Operating instructions/Betriebsanleitung E-10, E-11
GB
3