ChiQ CFD337NEI42 Handbuch Seite 12

EN
Smart ECO
When Smart ECO is enabled the temperature is set to +5°C in the re-
frigerator compartment and to –18°C in the freezer compartment. These
are optimal temperature settings. To enable or disable Smart ECO, touch
the "Function" sensor repeatedly to cycle through available functions.
When the Smart ECO icon flashes, touch "OK" to confirm.
Note: If you do not touch "OK" within 5 seconds, the function will not be
activated. Smart ECO will be deactivated when you enable the Holiday or
Fast Freezing function.
Open door alarm
If the door remains open for more than 3 minutes, you will hear beep-
ing. Touch any sensor on the control panel to mute the beeping. After
another 3 minutes, you will hear beeping again. Beeps will continue until
you close the door.
Non-volatile appliance settings and compressor protection
In the event of a power outage, the appliance settings will not be reset.
When the power is restored, the appliance will operate with the same
settings as before the power outage. If the power is restored within less
than 5 minutes, the compressor will start with a delay. This prevents
damage to the compressor.
Elevated temperature alarm
If the temperature inside the freezer compartment is higher than –10°C
when you plug in the appliance to power, the freezer compartment tem-
perature will flash on the display. The temperature will stop flashing after
a few seconds or when you touch any sensor on the control panel.
Error Codes
Contact the service centre when E0, E1, E2, EH, EF or EC appears on the
display.
Inverter icon
This icon displays the status of the compressor. When the compressor
is running, the symbol lights up. When the compressor stops working,
it will automatically go out. To enable or disable the Inverter icon, touch
the "Function" sensor repeatedly to cycle through the available func-
tions. When the Inverter icon flashes, touch "OK" to confirm
Child Lock
The appliance features a child lock safety device. The Child Lock func-
tion is especially useful when cleaning. The Child Lock function is acti-
vated automatically 3 minutes after you last used the control panel or
opened or closed the door. Touch and hold the "OK" sensor for 3 sec-
onds to deactivate the Child Lock