Transport, Packaging And Storage; Commissioning, Operation - WIKA Eco Betriebsanleitung

4. Transport, packaging ... / 5. Commissioning, operation

4. Transport, packaging and storage

4.1 Transport
Check the differential pressure gauge for any damage that may have been caused by
EN
transport.
Obvious damage must be reported immediately.
4.2 Packaging and storage
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g. change
in installation site, sending for repair).
Permissible conditions at the place of storage:
Storage temperature: -30 ... +80 °C
■
Humidity: 35 ... 85 % relative humidity (no condensation)
■

5. Commissioning, operation

5.1 Installation and mechanical connection
In accordance with the general technical regulations for pressure measuring instruments
(e.g. EN 837-2 "Selection and installation recommendations for pressure gauges").
air2guide standard gauges are calibrated in vertical position and should be installed
in the same position to avoid loss of class accuracy. If a different installation position
is required for air2guide instruments, please specify when ordering. Instruments with
high measuring ranges can be installed in a different, non-vertical mounting position by
simply adjusting the zero point.
8
CAUTION!
Damage through improper transport
With improper transport, a high level of damage to property can occur.
▶
When unloading packed goods upon delivery as well as during
internal transport, proceed carefully and observe the symbols on the
packaging.
▶
With internal transport, observe the instructions in chapter
4.2 "Packaging and storage".
WIKA operating instructions, model A2G-05