Cleaning And Storage; Disposal - Beurer EM 28 Gebrauchsanweisung

7. Cleaning and storage

Cleaning the control unit
Important
Before beginning the cleaning process, disconnect the
connection cable from the control unit and the cuff and
remove the batteries.
Clean the control unit after use with a soft, slightly damp
cloth. If it is very dirty, you can also moisten the cloth with
a mild soapy solution. Do not use any chemical or abrasive
cleaning agents. Ensure that no water gets inside the control
unit.
Cleaning the wrist cuff
Important
1. Before beginning the cleaning process, disconnect the
connection cable from the cuff.
2. C lean the cuff carefully in lukewarm, soapy water. Do not
use hot water. Afterwards, rinse it thoroughly with water
so that no soap remains on the cuff.
3. Then carefully pat the cuff dry with a towel and leave it
to dry.
Warning
• If the cuff is damaged, it must be replaced.
• Before putting the cuff on again, first clean the body parts
to be treated.
Storage
• Switch off the control unit and disconnect the connec-
tion cable.
• Remove the cuff.
• Disconnect the connection cable from the cuff.
• Put the control unit, the cuff and the connection cable in
their original packaging.
• Store the original packaging in a cool, dry place that is
inaccessible to children.
• Remove the batteries from the device if you will not be
using it for a prolonged period of time. Leaking batteries
may damage the device.

8. Disposal

For environmental reasons, do not dispose of the
device in the household waste at the end of its ser-
vice life.
Dispose of the device at a suitable local collection or
recycling point in your country. Dispose of the device in
accordance with EC Directive – WEEE (Waste Electrical and
Electronic Equipment).
If you have any questions, please contact the local author-
ities responsible for waste disposal.
The empty, completely flat batteries must be disposed of
through specially designated collection boxes, recycling
28