Sony SU-WL450 Installationsinformationen Seite 14

3
Preventing the bottom of the TV
from shifting.
• Take up the slack of Belt  and attach it
to the wall tightly.
2-a
 Belt
• Use a 5 mm diameter screw or equivalent
(not supplied).
Note
 Try to pull the bottom of the TV towards yourself
slightly, to make sure that it does not move
forward. If there is any movement, it is not fixed
correctly, and the Belt  should be secured firmly
again.
XR-65A9xJ / 55A9xJ only
WARNING
 Be sure that two or more persons (three or more
persons for 189.3 cm (75 inches) and above TV set) hold
the TV when carrying it.
2-b
 Belt
− 14 (GB) −
1
Lift the TV.
• For the location of the Pulleys  to hang
on the Base (20)  or Base Adaptor ,
refer to "Base Adapter  fitting location"
on page 18.
• Make sure that the rear of the TV touches
the Base (20)  or Base Adaptor  when
holding the TV.
Note
 Hold the TV securely with both hands.
2
Install the TV onto the Base (20)
 or Base Adaptor .
• Gently slide down the TV and hang the
Pulleys  attached to the rear of the TV
to the Base (20)  or Base Adaptor ,
making sure to confirm the shape of the
holes.
• After installing the TV on the wall, confirm
the Pulleys  are firmly latched into the
Base (20)  or Base Adaptor .
• Release both hands slowly to ensure that
the TV does not fall.
 Pulley