Telecom Behnke 20-2940-IP Anleitung Seite 26

IP camera Instructions
GB GB
Introduction
Camera LED illumination default setting: only
turned on during a call.
IP basic electronics
*
IP camera may only be operated with cover. Operation without the camera cover will damage the
camera. When opening the camera cover for service purposes, only loosen the two outer screws and
carefully lift off the camera cover. Heat sink in cover connected to camera.
26
Input Output
LAN
Camera module, rear view
Network cable (including PoE to camera)
Connection cable to power
the illumination ring (43-9582 / 43-9582A
not illuminated)
Turning on the LED illumination depends on
the operations mode set for relay 2 of your
SIP door intercom.
www.behnke-online.com
*