Grundig MS 300 Benutzeranweisungen Seite 42

CASSETTE MODE ____________________________
Selecting the cassette input source
1 Press the
button on the unit or MODE button
on the remote control to select the CASSETTE
mode.
Playback
1 Open the front flap which is marked with
»OPEN« on the front panel.
2 Press »
« to open the tape compartment.
/
3 Insert a cassette in the compartment with the
open side facing downwards and the full reel on
the left side and close the compartment.
4 Press » « to start playback.
• The button is automatically released at the end
of the tape, except if pause function has been
activated.
5 To pause playback press »
playback by pressing » « again.
6 End playback with »
Note:
• The source cannot be changed while recording
a cassette.
Fast forward and reverse search
1 In stop mode, press »
• »
« rewinds to the beginning, »
forwards to the end.
42 ENGLISH
« and resume
«.
/
« or » «.
« fast
Recording onto cassette
1 Press » / « to open the tape compartment.
Put in a recordable cassette.
2 Go to other source besides cassette playback.
3 Press »
« and »
time to record.
Erase protection
• Each new recording writes over the previous
recording.
• You can protect your recordings against
inadvertent deletion by breaking the protection
tab in the opening in the spine of the tape.
• Purchased recordings on music tapes are
already protected against accidental deletion.
• If you wish to record on a protected tape, seal
the opening with adhesive tape.
Note:
• Only use NORMAL-type cassettes (IEC I) for
recording. CHROME (IEC II) or METAL (IEC IV)
tapes are not suitable.
« buttons at the same