Remaining Hazards; Use Only As Authorized - Scheppach Chisa 7.0 Originalanleitung

nected to the power supply.
Trainees must be at least 16 years of age, but may only
operate the machine under adult supervision .
from their work.
tension if a second person is working at the circular saw-
bench removing cut workpieces. The second person may
not stand anywhere else but at the take-off table end.
and wood scrap.
and other jewelry.
– see Electrical Connection.
moved or rendered unusable.
chine may only be carried out when the motor is switched
off. Pull the power supply plug and wait for the rotating
tool to completely stop.
rectifying any malfunctions.
and covers must be mounted.
rectifying any malfunctions.
the power supply plug.
even if only minor changes of place are envisaged. Prop-
erly reconnect the machine to the supply mains before
recommissioning.
completing repair and maintenance procedures.
m Use only as authorized
The machine corresponds to the valid EC guideline.
front and at the rear using both hands and lift the ma-
chine.
placed firmly upon a stable stand resembling a table.
The working height should be 850 mm.
chine must be clear of interfering foreign matter to pre-
vent accidents occurring.
i.e. nails or screws.
machining of wood and materials similar to wood. Only
original scheppach tools and accessories may be used.
Please observe the „Special Tool Accessories".
condition in accordance with its designated use and the
instructions set out in the operating manual, and only
by safety-conscious persons who are fully aware of the
risks involved in operating the machine. Any functional
disorders, especially those affecting the safety of the
machine, should therefore be rectified immediately.
generally recognized safety-technical rules must also be
10 english
- adhered to.
and operated by persons familiar with it and instructed
in its operation and procedures. Arbitrary alterations to
the machine release the manufacturer from all responsi-
bility for any resulting damages.
- nal accessories and original tools made by the manu-
facturer.
is not responsible for any damages resulting from unau-
thorized use; risk is the sole responsibility of the opera-
m
The machine has been built using modern technology in ac-
- cordance with recognized safety rules. Some remaining haz-
ards, however, may still exist.
-
hands if it is incorrectly fed.
is not properly secured or fed, such as working without
a limit stop.
to injuries caused by electricity.
accessories must be observed and carefully read when
scheppach special accessories are used.
maining hazards which are not yet evident may still be
present.
Fig. 1
instructions in „Safety Precautions", „Proper Use" and
in the entire operating manual.
Switch
Depth stop
Table stop
-
Table
Enclosed

Remaining hazards

Operating handle
Gas spring
Chisel and bit
-
-
Work stop
Handwheel
Access door