Battery Replacement - Beha-Amprobe 2100-Alpha Bedienungsanleitung

BATTERy REPLAcEMEnT

If the LED for continuity Rx
when the test probes are short-circuited,
the batteries may be dead. Replace the
batteries.
• Disconnect the voltage tester
completely from the measuring circuit.
• Using a screwdriver, unscrew the
two metal screws on the battery
compartment until the battery
compartment cover can be removed.
noTE: Do not unscrew the screws
completely.
• Remove used batteries.
• Insert new batteries, type 1.5 V IEC
LR03. Ensure that the polarity is correct.
• Correctly insert battery compartment
cover and screw down.
W
If batteries have leaked, the instrument
must no longer be used and must be tested
by our factory service department before it
can be used again.
W
Never attempt to dismantle a battery
cell! The electrolyte in the cell is extremely
alkaline and electroconductive. Risk of
chemical burns! If electrolyte comes into
contact with your skin or clothing, these
spots must be rinsed immediately with
water. If electrolyte gets into your eyes,
rinse them immediately with clean water
and consult a doctor.
Please bear this in mind and also consider
our environment. Do not throw used
batteries into the normal household waste,
but hand the batteries over to hazardous
waste facilities or hazardous waste
collection centers.
W
Observe the currently valid regulations
concerning the return, recycling and
disposal of used batteries and
accumulators.
7
10
is not lit
Screws