Battery Replacement & Care; Low Battery Indication - Beha-Amprobe NCV-1000-EUR Series Bedienungsanleitung

EMC
Compliance
Certifications
BATTERY REPLACEMENT & CARE

Low Battery Indication

The NCV-1030/1040-EUR Voltage Probe provide a
low battery indication in the form of a very slowly
blinking red LED upon power on when battery level
is low and the batteries should be replaced. At that
point no voltage indication is possible.
The NCV-1020-EUR does not provide the same
indication; instead, batteries will need to be replaced
when no LED appears upon power on.
Battery Replacement
To remove the battery cap, use the thumb grip to
pull it upwards and outwards. Remove batteries
and replace with (2) AAA 1.5 V alkaline batteries,
noting the battery orientation as shown on the
side of the Voltage Probe. Replace the cap.
If the Voltage Probe will not be used for a long
period of time, remove the batteries.
Cleaning
The Voltage Probe can be cleaned with a mild
solution of soapy water. Apply sparingly with a
soft cloth and allow to dry completely before
using. Do not use aromatic hydrocarbons, gasoline,
or chlorinated solvents for cleaning.
IEC 61326-1
Korea (KCC): Class A Equipment
(Industrial Broadcasting &
Communication Equipment)
This product meets requirements
[1]
for industrial (Class A) electromagnetic
wave equipment and the seller or
user should take notice of it. This
equipment is intended for use in
business environments and is not to
be used in homes.

Latch
7
[1]
Battery Cap