Putting Into Operation, Configuration And Management; Putting Into Operation; Use Of The Internal Web-Server (Web-Gui) - Elcon Nect next BIG 101 Serie Bedienungsanleitung

3 Putting into operation, Configuration and Management

3.1

Putting into operation

After application of the supply voltage, Activation of WAN interface and completed self-
configuration (IP address for Management port) the BIG 101x inclusive its managementfunc-
tion is ready for work. The complete line between DSLAM and BIG 101x will be put into
operation by your operator. It has a preset configuration or makes the required settings auto-
matically by auto-configuration. Normally, there is no need to perform further configuration
settings directly on the BIG 101x. So the following chapters only provide a description of
additional functions, which are used for polling of status information of the BIG 101x, or
which may be required for troubleshooting in case of need.
Prerequisite for proper operation of your data link / LCT via the BIG 101x is the correct in-
stallation of the network interface card to your PCs. Detailed information on this should be
received in the documentation provided by the card manufacturer. Further questions about
configuration of your PC should be addressed to your Service Provider.
3.2

Use of the internal Web-Server (Web-GUI)

The device-internal Web-Server enables the user to call the Web-GUI (Graphical User Inter-
face) with the help of a PC to be connected to the LCT-Port (LAN1).
For this, all standard browsers (Internet Explorer, Firefox, Safari, Opera, etc. can be used as
Web-Browser). To get access to the Web-GUI, please proceed as follows:
(1) Make sure that the network settings on your computer allow for an automatical as-
signment of the IP-address via DHCP-server. In case of doubt ask your network ad-
ministrator to perform the settings.
(2) Link the LAN-interface of your computer with the LAN1-socket of the BIG 101x by
means of a LAN-(Ethernet) cable.
(3) When the computer is linked with the BIG 101x, an IP-address will be automatically
assigned.
It is also possible to set a fixed IP-address at the PC. To this effect, the following data have to
be assigned to your computer:
Address range
Subnet mask
Gateway-address
User name
regular
user
Password
User name
advanced
user
Password
Now open the Web browser of your computer and enter the following information into the
address line: http://192.168.1.1
40
Default setting
192.168.1.2 to 255
255.255.255.0
192.168.1.1
admin
admin
isp-admin
isp-admin
BIG 101x
Individual user setting
Version: 2010/12/01