Housing And Position Of The Connectors / Leds - Elcon Nect next BIG 101 Serie Bedienungsanleitung

BIG 101x
The mounting instructions can be found on the drilling template. During installation the
BIG 101x must be disconnected from the electricity grid, otherwise the user is at danger to
touch active parts of the device. Use the drilling template to mark and drill the needed holes
and insert the screws that are enclosed in delivery. Then hang up the device on the two
screws. After this connect your terminating equipment (PC/ Router) to the LAN2-interface,
and link the SHDS Lines that come from the DSLAM to the WAN port. At the end connect
the enclosed mains unit to the mains socket and the 12-VDC port on the BIG 101x. The de-
vice is now ready for operation: this is indicated by the PWR-LED (see section 2.9 LED sig-
nalling).
2.4

Housing and position of the connectors / LEDs

The device BIG 101x is accommodated in a combined desktop-/ wallmount housing. The
connectors are placed in the bottom part, whereas the LED display can be found in the upper
casing part (see figures below).
Figure 3: Position of connectors and display/ operating elements of the BIG 101x
34 Version: 2010/12/01