AFRISO RG 210 Betriebsanleitung Seite 57

6 Commissioning
 Verify that the product has been properly mounted and electrically con-
nected.
6.1 Setting the operating mode
 Verify that the upper part of the housing has been removed from the base.

A
A. Mains fuse F1
B. Slide switch for operating modes
C. Operating mode "Probe 1"
1. Loosen the grey cover from the upper part of the housing by means of a
small screwdriver.
2. Pull the printed circuit board out of the upper part of the housing.
3. Se the desired operating mode with the slide switch (B), see chapter
"Function".
4. Refit the printed circuit board.
5. Close the product.
Commissioning
D. Operating mode "Filling"
E. Operating mode "Emptying"
B
C
D
E
RG 210
EN
25