Status; Start/Stop; Start All; Stop All - urmet 1093 Schnellanleitung

3.1.2

STATUS

This item (not selectable) shows the status of each video channel by means of a series of LEDs.
The following modes can be displayed:
green
red
amber →
3.1.3

START/STOP

This option is used to start/stop the recording on a certain video channel.
To set, select the respective check box using "◄►" and press "ENTER" or "EDIT".
Symbol " " indicates that recording can be started on a selected channel; symbol "×" indicates that the recording can be stopped.
The following will light up on a channel when recording is started:
pink icon on the camera status bar shown on the monitor.
3.1.4

START ALL

Select this option and press "ENTER" or "EDIT" to start recording all video channels at the same time.
3.1.5

STOP ALL

Select this option and press "ENTER" or "EDIT" to stop recording all video channels at the same time.
IMPORTANT NOTE
To proceed with manual recording:
the user must have the corresponding privileges
at least one hard disk must be installed in the device
the hard disk must be formatted
3.2

RECORDING SEARCH

Press "PLAY" on the front panel of the device in LIVE mode.
A password must be entered by default. The following window will appear.
The selected item is highlighted.
Press arrows "◄►" to point the cursor to the various menu items.
Press "ESC". to quit the menu.
3.2.1

CHANNEL

Use this option to select the channel to be played.
Use "▲▼" to select.
3.2.2

T REC TYPE(SEARCH BY EVENT)

This option can be used to select the recording type to be sought.
Possible options are: "All time", "Motion", "Allarms", "Command" and "All".
Use "▲▼" to select.
DS1093-013
→
the channel is not active
→
the channel is recording (manual, real time, motion detection, external alarm)
→
transmitting on the network
recording and transmitting on the network
Figure 34: playaback menu
46