General Settings; Switch-On; Switch-On From Rear Panel; Dsp In Itialisation - urmet 1093 Schnellanleitung

1

GENERAL SETTINGS

Dear Customer,
Thank you for having purchased this Urmet product.
This document is just a quick user manual allowing you to install the Digital Video Recorders Urmet Domus S.p.A. models
1093/064, 1093/065 and 1093/066 and to start using their main functions in a short time.
For more detailed information about the devices, refer to the full instruction manual inside the CD provided with the product.
1.1

SWITCH-ON

The device can be switched on in two ways.
From the rear panel (device not powered – power LED off)
From the front panel (device powered – red power LED on).
1.1.1

SWITCH-ON FROM REAR PANEL

Plug the power connector into the specific socket on the back of the unit and switch
The green power warning light on the front panel will light up. The welcome page will appear on the monitor.
The device initialisation processes will appear at this point.
The first row of icons represent DS
A red icon "X" means that errors occurred during initialisation. Contact the retailer or authorised installer.
The second row of icons represent hard disk initialisation.
IDE1, IDE2 icons, etc., appear.
A red icon "X" Means that the corresponding hard disk has either not been installed or has not been id
or authorised installer.
IMP OR TANT NOTE
The device wi ll output an
in the "Exceptions" menu.
The green "READY" LED will light up on the front panel at the end of the initialisation operations.
1.1.2

SWITCH-ON FROM FRONT PANEL

Simply press on the fron
up, the welcome page will ap
The DVR shows the connected video channe
In this m ode, the DVR will not
1.2

SWITCH-OFF

The device can be switched off in two ways.

direct switch-off

switch-off from main menu

By default, a password must be entered to switch the device off (with either procedure).
Make sure that no recording or playback is in progress before switching the unit off to prevent damage to the hard disk.
1.2.1 DIRECT SWITCH-OFF
Hold button pressed for five seconds. A confirmation dialog will appear. Press "ENTER" to confirm.
1.2.2 SWITCH-OFF FROM MAIN MENU
Press "MENU" to access the main menu. Select "UTILITIES by repeatedly pressing "►" and press "ENTER". Select "SWITCH-
OFF" by repeatedly pressing "►" and press "ENTER". Press again "ENTER" to confirm.
The power LED on the front panel of the DVR is red when the device is off and powered.
DS1093-013
P initialisation.
HARD DISK INITIALISATION
acoustic signal if the hard disk is either not installed or not found. The alarm option can be deactivated
t panel of the DVR when the power LED is red to power the device: the green power LED will light
pear followed by the device initialisation processes.
ls after it is switched on: this is called "LIVE" mode.
record and will not play recorded sequences back.
Figure 21: welcome page
DSP IN ITIALISATION
31
on the back of the unit to position 1.
entified. Contact the retailer