Type Bit Rate; Quality; Pre Rec; Post Rec - urmet 1093 Schnellanleitung

2.2.2.2

Type bit rate

This option can be used to select the bit rate type to be used for recordings.
Possible options are: "Fixed" and "Variable.
Use "▲▼" to select.
If "Fixed" is selected, the device will use the set bit rate and video quality cannot be selected. The required bit rate is set using the
"Bit Rate" option.
By selecting the "Variable"" option, the device will edit the effective bit rate according to the video image movement. The DVR will
use a low bit rate if there is not much movement and a high bit rate in the event of scenes with lots of motions.
The bit rate used by the device is set using the "Max Bit Rate" option.
By selecting the "Variable"" option, the quality of the recorded images can be set in the "Quality" option.
2.2.2.3

Quality

This option can be used to set the recorded image quality.
Possible options are: "Lowest", "Low", "Average", "High", "Highest" and "Higher".
Use "▲▼" to select.
Smaller files will result if minimum image quality is selected. Larger files will result if high image quality is selected. Higher quality
corresponds to better defined images during playback. Lower quality should be selected to save hard disk space.
IMPORTANT NOTE
The "Quality" option is available only if a "Variable" bit rate was previously defined.
2.2.2.4

Pre REC

The recording will contain the video feed prior to the alarm for the set time in the event of a motion detection or external alarm
event.
Possible options are: "Nr.", "5s", "10", "15s", "20", "25", "30" and "Max".
Use "▲▼" to select.
Select "Nr." for no "pre-recording".
2.2.2.5

Post REC

The recording will contain the video feed following the alarm for the set time in the event of a motion detection or external alarm
event.
Possible options are: "5s", "10", "30s", "1Min", "2Min", "5Min" and "10Min".
Use "▲▼" to select.
2.3

NETWORK MENU

Description
Use this menu to configure the DVR according to the parameters of the Ethernet network to which it is connected.
Position the "Active Frame" on the "NETWORK" icon and press "ENTER".
IMPORTANT NOTE
The default IP address of the DVR is: 192.0.0.64. Use this menu to assign to the DVR an IP address which is not used
in the network by other devices to prevent conflicts.
Connect the DVR to the network after having correctly configured the IP address.
The following window will appear:
DS1093-013
BIT RATE FIXED
BIT RATE VARIABLE
Figure 29: network menu (basic settings)
42