Password Change - urmet 1093 Schnellanleitung

The selected item is highlighted.
Press arrows "◄►" to point the cursor to the various menu items.
Select "CONFIRM" and press "ENTER" to make the changes effective.
Select "CANCEL" and press "ENTER" to cancel the changes.
Press "ESC" to go back by one step.
Press "ESC" several times until the configuration window closes to quit the configuration menu.
The box contains a list of the default users. The features of the default administrator are:
name →
password
The "admin" name cannot be edited. The password can be edited.
IMPORTANT NOTE
•
THE DEFAULT PASSWORD IS "12345".
•
It is advisable to change the default password to prevent intrusions.
•
To enter/edit the password, remember to press "SHIFT" (make sure that the STATUS LED lights up) followed
by the number keys. At the end of the operation, press "SHIFT" to go back to default functions. The STATUS
LED will go out.
•
Do not lose or forget the programmed password.
•
Take note of the new password and keep it in a safe place.
•
It will not be possible to access the device in local mode (i.e. using the front panel) if an alphanumeric
password is chosen (using the dedicated software).
2.4.1

PASSWORD CHANGE

Use "◄►" to shift the "active frame" onto the "Password" box, press "Edit" and enter a new password.
The password is a maximum 16 number combination. To enter the sequence of numbers in a password, use the number keys on
the front of the panel (press "Edit" to cancel a character). The entered numbers will be replaced by a "*" symbol on the screen for
privacy.
After entering the password, press "Enter" to quit entry mode.
Use "◄►" to shift the "active frame" onto the "Verify" box, press "Edit" and enter the new password.
The password will be saved and become effective if the two passwords are the same.
An error message will appear indicating the fault if the entered password and the check password are different.
In this case, press "Enter" to go back to the previous menu and repeat the entry procedure.
IMPORTANT NOTE
•
Only numeric passwords if new users are programmed in local mode (i.e. using the front panel of the DVR).
Alphanumeric passwords may be created using the software.
•
It will not be possible to access the device in local mode (i.e. using the front panel) if an alphanumeric
password is chosen.
•
For safety reasons, the password is case-sensitive.
DS1093-013
admin
→ 12345
Figure 31: password error message
44