Sanus Systems VM200 Montageanweisungen Seite 4

Step 1: Mount Monitor Brackets to a television with a flat back
First, determine the diameter of the Bolt (g,h,i) your TV requires by hand threading them into the threaded insert on the back of the TV. If
you encounter any resistance stop immediately! Once you have determined the correct diameter, see the appropriate Diagram below. You
will thread the Bolt through the appropriate Lock Washer (m,n,o), the corresponding Washer (p,q), the Monitor Bracket (b,c), and finally
into the TV. Make sure the Monitor Brackets are vertically centered and level with each other. See the appropriate Diagram below.
Note: For televisions with a curved back, or an obstruction near the threaded insert see Step 2.
M4 Diameter Bolt
M5 Diameter Bolt
c
m
p
c
n
p
g
h
M6 Diameter Bolt
b
q
Diagram 1
i
o