Dometic PERFECTVIEW VT100DIG Montage- Und Bedienungsanleitung Seite 15

VT100DIG
➤ Connect the blue cable of the transmitter module (fig. 6 5, page 5) depending on the type
of camera.
– Camera without motorised protective cover to an active positive cable
– Camera with motorised protective cover to the reversing light
➤ Connect the camera connector (fig. 6 4, page 5) to the camera.
Connecting the transmitter module to the reversing light (no continuous operating
voltage)
I
NOTE
• These connection options only work with the cameras CAM50C, CAM60CM or
CAM30C.
• On some vehicles, the reversing light only works when the ignition is switched on.
In this case, you must switch on the ignition in order to identify the positive and earth
wires.
• If the transmitter module is only connected via the reversing light, the system pairing
cannot be started in the reverse gear.
➤ Connect the red cable of the transmitter module (fig. 6 7, page 5) to the positive wire (+) of
the reversing light.
➤ Connect the black cable of the transmitter module (fig. 6 8, page 5) to the earth wire (–) of
the reversing light or to earth (bodywork).
➤ Connect the blue cable of the transmitter module (fig. 6 5, page 5) to the positive wire of the
reversing light.
➤ Connect the camera connector (fig. 6 4, page 5) to the camera.
A
NOTICE!
The green cable may not be used.
Pairing the transmitter and receiver is only possible when reverse gear is engaged via
the button!
7.3 Connecting electrical power to the receiver module
➤ Connect the green cable of the receiver module (fig. 7 5, page 5) to the reversing switch.
➤ Connect the black cable of the receiver module (fig. 7 6, page 5) to earth (bodywork).
➤ Connect the monitor connector (fig. 7 4, page 5) to the monitor.
➤ Switch on the monitor.
✓ The monitor displays the message "Wait Tx Signal ...".
EN
Connecting electrical power to the radio link
15