Changing The Basic Settings; Setting Energy-Saving Mode; Cleaning; Suitable Cleaning Agents - Bosch VBD5780S0 Gebrauchsanleitung

Cleaning

en

Changing the basic settings

The function selector must be set to the "Off" position.
Press and hold the
v
1.
The first basic setting will appear on the display,
e.g. .
™‹‚ ‚
Use the temperature selector to change the setting
2.
as required.
Use the button to navigate to the next basic
@
3.
setting.
Use the or button to continue going through all
A @
4.
the basic settings as described above, and use the
temperature selector if you want to change any of
these settings.
When you have finished, press and hold the
5.
button again for approx. 4 seconds to confirm the
v
settings.
This applies all the basic settings.
You can change the basic settings again at any time.
Demo mode can only be activated within 5 minutes of
connecting the appliance to the mains power supply.
Your changes to the basic settings will be
Note:
retained even after a power failure.

Setting energy-saving mode

You can save energy by reducing the display
brightness.You can set the display brightness under
basic setting ™‹... .
This setting changes the brightness of the display
Note:
while the appliance is in operation. In standby mode,
the appliance automatically reduces the display
brightness. The display is at its dimmest at night,
between the hours of 22:00 and 05:59.
40
button for approx. 4 seconds.
DCleaning
W ith good care and cleaning, your appliance will retain
C l e a n i n g
its appearance and remain fully functioning for a long
time to come. We will explain here how you should
correctly care for and clean your appliance.
:
Warning – Risk of electric shock!
Do not use any high-pressure cleaners or steam
cleaners, which can result in an electric shock.
:
Warning – Risk of burns!
The appliance becomes very hot. Never touch the
interior surfaces of the cooking compartment or the
heating elements. Always allow the appliance to cool
down. Keep children at a safe distance.

Suitable cleaning agents

Observe the following information to ensure that the
different surfaces are not damaged by using the wrong
type of cleaning agent.
Do not use any of the following
on the oven:
Any harsh or abrasive cleaning agents,
■
Cleaning agents with a high concentration of
■
alcohol,
Hard scouring pads or sponges,
■
High-pressure cleaners or steam cleaners.
■
Wash new sponge cloths thoroughly before use.
Area Cleaning
Appliance exterior
Stainless steel Hot soapy water:
front Clean with a dish cloth and then dry with a soft
cloth.
Remove flecks of limescale, grease, starch and
albumin (e.g. egg white) immediately. Corrosion
can form under such flecks.
Special stainless steel cleaning products suitable
for hot surfaces are available from our after-sales
service or from specialist retailers. Apply a very
thin layer of the cleaning product with a soft cloth.
Control panel Hot soapy water:
Clean with a dish cloth and then dry with a soft
cloth.
Do not use glass cleaner or a glass scraper.
Door panels Hot soapy water:
Clean with a dish cloth and then dry with a soft
cloth.
Do not use a glass scraper or a stainless steel
scouring pad.
Door handle Hot soapy water:
Clean with a dish cloth and then dry with a soft
cloth.
If descaler comes into contact with the door han-
dle, wipe it off immediately. Otherwise, any stains
will not be able to be removed.