Makita AN923 Betriebsanleitung Seite 7

ENGLISH (Original instructions)
1. Trigger
2. Change lever
3. Hook
4. Magazine
5. Contact element
6. Compressor air output per minute
7. Nailing frequency (times/min.)
8. Pneumatic tool oil
9. Nose adapter
10. Adjuster
SPECIFICATIONS
Model
Air pressure
Fastener
Magazine capacity
Pneumatic tool oil
Dimensions (L x H x W)
Min. hose diameter
Net weight
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
..... Read instruction manual.
....... Wear safety glasses.
....... Wear ear protection.
............. The tool has the capability of operating in
contact actuation mode.
.............. Do not use on scaffoldings, ladders.
Intended use
The tool is intended for the preliminary interior work such
as fixing floor joists or common rafters and framing work
in 2" x 4" housing.
The tool is for high-volume professional application only.
Do not use it for any other purpose. It is not designed to
Explanation of general view
11. Pusher
12. Pusher lever
13. Depress
14. Return
15. Nail stopper
16. Air socket
17. Air fitting
18. Contact actuation mode
19. Trigger lock
20. Single sequential actuation mode
Type Plastic strip nail (full round head)
Length
Diameter
Angle
559 mm x 347 mm x 109 mm
END106-4
ENE059-2
AN923
0.44 - 0.83 Mpa (4.4 - 8.3 bar)
50 - 90 mm
2.9 - 4.1 mm
21 degrees
64 - 74 pcs.
ISO VG32 or equivalent
8.5 mm
4.0 kg
drive fasteners directly on a hard surface like steel and
concrete.
PNEUMATIC NAILER/STAPLER
SAFETY WARNINGS
WARNING: Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in serious injury, electric shock
and/or fire.
Save all warnings and instructions for
future reference.
For personal safety and proper operation and
maintenance of the tool, read this instruction manual
before using the tool.
General safety
1. Any other use except for intended use of this tool
is forbidden. Fastener driving tools with continual
contact actuation or contact actuation shall only
be used for production applications.
2. Keep fingers away from trigger when not
operating this tool and when moving from one
operating position to another.
3. Multiple hazards. Read and understand the safety
instructions before connecting, disconnecting,
loading, operating, maintaining, changing
21. Hammer
22. Small rod
23. Ejection port
24. Driver
25. Pliers
26. Slot
27. Drain cock
28. Air filter
29. Oiler
30. Pneumatic oil
AN943
Paper strip nail (clipped head)
50 - 90 mm
2.9 - 3.3 mm
34 degrees
60 - 84 pcs.
455 mm x 365 mm x 109 mm
ENB132-1
7