Ex-Relevant Safety Regulations - i.safe MOBILE IS330.1 Kurzanleitung

be withdrawn from use and removed from any ex-hazardous areas immediately. Measures
must be taken to prevent any accidental restarting of the device. The safety of the device may
be compromised, if, for example:
Malfunctions occur.
The housing of the device shows damage.
The device has been subjected to excessive loads.
The device has been stored improperly.
Markings or labels on the device are illegible.
We recommend that a device displaying errors or in which an error is suspected be sent back
to i.safe MOBILE GmbH to be checked.

EX-RELEVANT SAFETY REGULATIONS

Use of this device assumes that the operator observes the conventional safety regulations and
has read and understood manual, safety instructions and certificate.
The following safety regulations must also be complied with:
Inside ex-hazardous areas the covers of all interfaces must be closed.
To ensure the IP-protection, it has to be ensured that all gaskets are present
and functional. There must be no large gap between the two halves of the housing.
The device may only be charged outside ex-hazardous areas using the i.safe PROTECTOR 2.0
or i.safe PROTECTOR 3.0 USB-cable or other equipment approved by i.safe MOBILE GmbH.
When using the IS-HS1.1 headset, the headset must be securely fastened to the ISM interface.
Physical connections to equipment other than the IS-HS1.1 headset are only allowed outside
ex-hazardous areas using the i.safe PROTECTOR 2.0 and i.safe PROTECTOR 3.0 USB-cable
or other equipment approved by i.safe MOBILE GmbH.
The device may only be charged at ambient temperatures between +5°C ... +35°C.
The device may not be exposed to any aggressive acids or alkalis.
The device may only be used in zones 1, 2, 21, or 22.
Only accessories approved by i.safe MOBILE GmbH may be used.
EX-RELEVANT SAFETY REGULATIONS FOR NORTH AMERICA
Conditions of Acceptability:
The battery shall only be charged outside the explosion hazardous areas only and using a
suitably certified Class 2 power supply with the following output parameters:
V = 5VDC I = 2000mA
The smartphone must be protected against excessive UV light emission and high electrostatic
processes.
The USB interface (type C) located at the bottom side is for data transmission and it is used
in non hazardous areas. It is not permitted to open the USB interface cover in hazardous
locations.
The ISM interface of the IS330.1 located at the right side can be used within hazardous areas
with approved headsets, Remote Speaker Microphones(RSM) and add-ons.
For the ISM interface connection the intrinsically safe approved accessories must comply with
entity parameters according to document 1029AD04 i.e. Headset IS-HS1.1 is approved to be
used on ISM interface. If the ISM interface is not used, it must be securely closed by the cover
provided for this purpose.
EN 5