Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
FAULTS AND DAMAGES
FAULTS AND DAMAGES
If there is any reason to suspect that the safety of the device has been compromised, it
If there is any reason to suspect that the safety of the device has been compromised, it
must be withdrawn from use and removed from any ex-hazardous areas immediately.
must be withdrawn from use and removed from any ex-hazardous areas immediately.
Measures must be taken to prevent any accidental restarting of the device.
Measures must be taken to prevent any accidental restarting of the device.
The safety of the device may be compromised, if, for example:
The safety of the device may be compromised, if, for example:
Malfunctions occur.
Malfunctions occur.
The housing of the device shows damage.
The housing of the device shows damage.
The housing of the device shows damage.
The device has been subjected to excessive loads.
The device has been subjected to excessive loads.
The device has been subjected to excessive loads.
The device has been stored improperly.
The device has been stored improperly.
The device has been stored improperly.
Markings or labels on the device are illegible.
Markings or labels on the device are illegible.
Markings or labels on the device are illegible.
It is recommended that a device which shows or which is suspected of faults and da-
It is recommended that a device which shows or which is suspected of faults and da-
mages is returned i.safe MOBILE GmbH for inspection.
mages is returned i.safe MOBILE GmbH for inspection.
EX RELEVANT SAFETY REGULATIONS
EX RELEVANT SAFETY REGULATIONS
Use of this device assumes that the operator observes the conventional safety
Use of this device assumes that the operator observes the conventional safety
regulations and has read and understood manual, safety instructions and certi cate.
regulations and has read and understood manual, safety instructions and certi cate.
The following safety regulations must also be complied with:
The following safety regulations must also be complied with:
Inside ex-hazardous areas the cover of the USB interface has to be closed.
Inside ex-hazardous areas the cover of the USB interface has to be closed.
To ensure the IP protection, it has to be ensured that all gaskets are present and
To ensure the IP protection, it has to be ensured that all gaskets are present and
functional. There must be no large gap between the two halves of the housing.
functional. There must be no large gap between the two halves of the housing.
The battery may only be charged outside ex-hazardous areas using the appropriate
The battery may only be charged outside ex-hazardous areas using the appropriate
charger or other equipment approved by i.safe MOBILE GmbH.
charger or other equipment approved by i.safe MOBILE GmbH.
The device may be charged only at temperatures in between 5 °C ... 35 °C.
The device may be charged only at temperatures in between 5 °C ... 35 °C.
The device must not be exposed to abrasive acids or bases.
The device must not be exposed to abrasive acids or bases.
The device must not be taken into zones 0, 1, 20 or 21.
The device must not be taken into zones 0, 1, 20 or 21.
Only accessories approved by i.safe MOBILE GmbH may be used.
Only accessories approved by i.safe MOBILE GmbH may be used.
FURTHER SAFETY ADVISES
FURTHER SAFETY ADVISES
Do not touch the screen of the device with sharp objects. Dust particles and nails
Do not touch the screen of the device with sharp objects. Dust particles and nails
Do not touch the screen of the device with sharp objects. Dust particles and nails
may scratch the screen. Please maintain the screen clean. Remove dust on the screen
may scratch the screen. Please maintain the screen clean. Remove dust on the screen
may scratch the screen. Please maintain the screen clean. Remove dust on the screen
with a soft cloth gently, and do not scratch the screen.
with a soft cloth gently, and do not scratch the screen.
Charge the device under indoor conditions only.
Charge the device under indoor conditions only.
Charge the device under indoor conditions only.
Do not put the device in environments with excessive temperatures, as this could
Do not put the device in environments with excessive temperatures, as this could
Do not put the device in environments with excessive temperatures, as this could
lead to heating of the battery, resulting in re or explosion.
lead to heating of the battery, resulting in re or explosion.
EN
EN
5
5
Werbung
Inhaltsverzeichnis
