Faults And Damages; Ex-Relevant Safety Regulations - i.safe MOBILE EXECUTIVE 1.0 Schnellstartanleitung

Safety Instructions

3 Faults and Damages

If there is any reason to suspect that the safety of the phone has been
compromised, it must be withdrawn from use and removed from any
ex-hazardous areas immediately.
Measures must be taken to prevent any accidental restarting of the
phone.
The safety of the phone may be compromised, if, for example:
 malfunctions occur.
 the housing of the phone or the battery shows damage.
 the phone has been subjected to excessive loads.
 the phone has been stored improperly.
 markings or labels on the phone are illegible.
It is recommended that a phone which shows or which is suspected of
faults and damages is returned to the manufacturer for inspection.

4 Ex-relevant Safety Regulations

Use of this phone assumes that the operator observes the conventional
safety regulations and has read and understood manual, safety instruc-
tions and certificate.
The following safety regulations must also be complied with:
 The housing of the phone must not be opened inside ex-hazardous
areas. This also relates to the battery compartment.
 The battery may only be exchanged or charged outside ex-hazardous
areas.
 Use only the appropriate battery type BPE01A or BPE01B.
 It is not allowed to carry spare batteries into Ex-hazardous areas.
 The battery may only be charged outside the Ex-hazardous area using
the appropriate charger or other equipment approved by i.safe
MOBILE GmbH.
 The battery may be charged only at temperatures in between
0°C..40°C.
 The phone must not be exposed to abrasive acids or bases.
 The phone must not be taken into zones 0, 1, 20, 21 or 22.
 Only accessories approved by i.safe MOBILE GmbH may be used.
6