Setting The Device Role And Resetting The Device (Only Comfortel Ws-500M) - Auerswald COMfortel WS-500S Betriebsanleitung

Initial Commissioning
Setting the Device Role and Resetting the Device (only COMfortel WS-
500M)
On delivery, all COMfortel WS-500M devices are
configured as "Only base station". To set up the multi-cell
system, one device must be configured as a DECT
Manager and Integrator.
Press the Device key
device's role. In programming mode, the two LEDs on the
F
front face show he currently selected role.
Important: Note that, when the device role is
changed, the device is reset to its state when delivered. All settings are
deleted. If a base station is already in use, ensure it is no longer connected
to another system.
1 Only base station The IP address is
2 Base station
+ DECT Manager
+ Integrator
3 Base station
+ DECT Manager
+ Integrator
4 Unsupported
device role
* LED display in programming mode
Do this to set the device's role:
Requirement:
• Booting has ended and the device is ready.
1. Press and hold the Device key for at least 10 seconds, until all LEDs go out.
The device is now in programming mode.
2. Press the Device key briefly, once or several times, until the necessary role
is selected.
The LEDs shine in accordance with the selected role (see table above).
3. Press and hold the Device key for at least three seconds, but for fewer than
10 seconds.
32
E
on the front face to change the
obtained automatically
The IP address is
obtained automatically
Static IP: 192.168.143.1
Subnet mask:
255.255.0.0
-
COMfortel WS-500S/500M - Instructions V02 08/2019
LED 1* (left) LED 2* (right)
Green
Blue Blue
Blue
Blue Green
E
F