Operation; Wiring Detail - Standard Unit; Wiring Detail - Telephone/Relay Initiate Unit - Eaton LED Beacon LD15 Technische Anleitung

4.0 Operation

Wiring detail – standard unit
Wiring detail – telephone/relay initiate unit
The operating voltage of the unit is stated on the unit
label. The beacon can be powered directly or initiated by
a 24Vdc relay or telephone ringing signal if requested
when ordered.
When installed as a direct switching device, the operating
mode can be set by means of a 3 way DIL switch
mounted on the underside of the electronics assembly.
The switch settings for the various modes of operation
are as follows:
MNde nN. SW1
0 0
1 0
2 0
3 0
4 1
5 1
LED BEacon LD15 TM253 Issue F October 2019 www.eaton.com
LED Beacon LD15
SW2 SW3 FuncoiNn
0 0 Off/Remote switching
0 1 120 fpm
1 0 60 fpm (default)
1 1 80 fpm
0 0 Steady
0 1 Double flash
English
3