YUNEEC H520E Schnellstartanleitung Seite 7

H520E Re-Bind
The aircraft and ST16E Ground Station
are already bound out of factory. There
is no need to bind them. Pilot can follow
the steps below if rebinding is needed.
Step 1: Power on the ST16E. Wait a few
seconds for all systems to be boot up.
Step 2: Tap the OFDM logo on the top
right conner, then Tap the unbind button.
Not Connected
Fly
Takeoff
RTL
Pause
Action
N/A
75%
OFDM USB WIFI
No data available
NO CAMERA
Unbind
Step 3: Tap the Unbind Confirm button
to finish the unbind process.
Not Connected
Fly
Takeoff
RTL
Pause
Action
Unbind Confirm
Step 4: Tap the OFDM logo on the top
right conner again.
Step 5: Power on the drone until see the
dialog box shown below.
Not Connected
Fly
Takeoff
RTL
Pause
Use a paperclip to set the Vehicle into Autobind mode
Click Next to proceed once LED starts blinking
Action
Next
N/A
75%
OFDM USB WIFI
NO CAMERA
N/A
75%
OFDM USB WIFI
NO CAMERA