YUNEEC H520E Schnellstartanleitung Seite 5

Power ON / OFF
NOTICE:
Please make sure all firmware is the
latest version. Firmware and the user
manual may be downloaded from web
site: www.yuneec.com. The quick start
guide does not replace the user manual.
Turn on the ST16E, and then press the
power button on H520E. Release the
button when the aircraft emits a rising
tune. Power the before powering on the
UAS.
Take Off
Press and hold the START/STOP button
for about 3 seconds to start the motors in
angle mode.
OPTION 1:
Slowly raise the left-hand stick to take
off.
OPTION 2:
Tap the Take Off and slide on the screen
to take off. There is also a Landing soft
key beneath the takeoff soft key that
may be used for Auto-Landing.
Retract Landing Gears
Raise the landing gear control using the
POWERING
landing gear control switch on the
ON ST16E
ST16E.
Land
Lower the landing gear using the same
control as used for retracting landing
gear. Lower the landing gear at least 12'
above the landing area.
Slowly lower the left-hand stick below the
center position, H520E will descend
slowly and land. After H520E lands, the
motors will stop after 2 seconds without
POWERING
any operation
ON H520E
GPS
9
VOL
12.6V
FSK
FSK
WiFi
Roll 120˚
WIFI
CHA
POS
CHA
POS
00 : 35 : 25
System Setting
300M
125km/h
Pitch 0˚
D/R 0˚
Channel Setting Model Se