EN
General Assembly and Maintenance Tips
strongly suggest reading through this manual completely before proceeding.
First Flight Preparation
Remove and inspect contents
Begin charging flight battery
Assemble Stinson Reliant
Install receiver
Install fully charged battery
Bind the receiver to a transmitter, if applicable
Perform the Control Direction Test with the transmitter
Adjust flight controls and transmitter
Perform a radio system Range Check
Maintenance After Flying
Turn off transmitter (Required for Safety)
Remove flight battery from aircraft
Recharge flight battery
Clean aircraft (wipe off dirt, etc.)
Repair or replace all damaged parts
Carefully disassemble and store aircraft
Store flight battery apart from aircraft and monitor the battery charge
Make note of flight conditions and flight plan results, planning for future flights
Installing Pushrods on Control Horns
on the pushrod. Make sure transmitter trims are
centered before making this adjustment.
pushrod.
pin in a selected hole in the control horn.
the control horn.
Downloaded from
www.Manualslib.com
(Required for Safety)
1.
2.
3.
manuals search engine
Activity
see page 9
Activity
PNP
PNP
4.
5.
6.
BNF
BNF