Attach Cover; Remove Cover - Truma S 5004 E Einbauanweisung

Version with lighting
Observe the ESD-regulations!
The cover is delivered with pre-mounted sensor electronics.
The plugs of the control panels on the sensor PCB can be in-
serted in any sequence. Fix the cables to the clamping bow.
63
22
23
The lighting is supplied with power via the TEB-3 fan or a sep-
arate cable.
If the device is operated without the TEB-3 fan, a separate
12 V cable needs to be fitted for the lighting (part no. 30090-
38100) from the fused onboard power supply (alternating cur-
rent ripple <1.2 Vss).
Place the cover (62) on the support (60) and click in. Make
sure that the cables are laid without any bends and are not
jammed.
Place the control knob (51 – gas) on the control rod (7) so that
the marking points to the "0" position.
22
63
23
60
Fig. B
Clip in the sign (65) to the mica window cover (left for right
installation and right for left installation).
16
63
0
1
2
3
62
51
62
63
50
0
1
5
4
2
3
7

Attach cover

Suspend the cover (1) in the bottom bearing and pivot in (2)
until the lock audibly clicks into place. Check the tight fit by
pulling.
51
50
5
4
1

Remove cover

Only remove the cover with the heating switched off
and cold.
By simultaneously pressing both closure levers (64) outwards,
the cover is unlocked. It can be pivoted out and lifted out of
the lower bearings.
2
64