Retrofitting Components; Equipping The Condenser Disk - Leica DM1000 Bedienungsanleitung

14. Retrofitting Components

14.1

Equipping the Condenser Disk

• Turn the stage upwards and lower the
condenser.
• Remove the condenser by loosening the
condenser's clamping screw.
Condenser UCL/UCLP
• Remove out the screw (55.1) completely.
• Turn back the centering screws until the light
rings, λ - and λ/4 - compensator* and lens*
2.5x can be inserted.
The largest hole
observation (= BF), the slightly smaller ones
are for light rings, λ - and λ/4 - compensator
or lens* 2.5x.
Fig. 55 Condenser UCL
1 Fixing screw for condenser disk
is for brightfield
1
14. Retrofitting Components
Notes:
If you use a smaller hole for brightfield, the
maximum illumination aperture cannot be used.
The lettering (e.g. DF, PH 1 ....., λ) must point
upward, the λ or λ/4 compensators must be
inserted with the correct orientation: The notch
must point towards the center of the disk! The
lettering of the components should
to the marking at the opposite position (outer
edge of the disk).
• Tighten the centering screws until the
components are roughly in the center of the
holes.
Fig. 56 UCL condenser disk
1 Condenser disk
2 Light ring or λ− or λ/4-compensator
3 Centering screws
4 Axis
5 Centering keys
6 λ- oderλ/4-Platte
7 2.5 x...20 auxiliary lens
correspond
57