Handling Acids And Bases; Changing Fuses - Leica DM1000 Bedienungsanleitung

Cleaning Glass Surfaces
Remove dust on glass surfaces with a fine, dry
and lint-free brush, or by blowing with a blow
bag or vacuum suction.
Carefully remove stubborn dirt on glass surfaces
with a clean cloth moistened with distilled
water. If the dirt still cannot be removed, use
pure alcohol, chloroform or benzine.
Cleaning Objectives
Caution!
The objective may not be unscrewed during
cleaning. If damage appears on inner sur-
faces, the objectives must be sent to your
Leica dealer for repair. We also advise
against cleaning the inside surfaces of the
eyepieces.
The front lenses of objectives are cleaned as
described under "Cleaning Glass Surfaces". The
upper lens is cleaned by being blown off with a
pneumatic pump.
Fig. 54
Fuse module
Removing Immersion Oil
Caution!
Follow safety instructions for immersion oil!
First, wipe off the immersion oil with a clean
cotton cloth, and then re-wipe the surface
several times with ethyl alcohol.

12.3 Handling Acids and Bases

For examinations using acids or other aggres-
sive chemicals, particular caution must be
taken.
!
Caution:
Never allow the optics and mechanical parts
to come into con-tact with these chemicals.
12.4

Changing Fuses

The fuse module (fig. 54) at the back of the stand
can be removed with a sharp object.
Fuse data→ p. 8
Order no.→ p. 56
Caution!
Never use any fuses as replacements other
than those of the types and the current rat-
ings listed here. Using patched fuses or
bridging the fuse holder is not permitted. The
use of incorrect fuses may result in a fire
hazard.
12. Care of the Microscope
55