Wiring - ANSMANN FM6.0 Originalbetriebsanleitung

ORIGINAL OPERATING INSTRUCTIONS - ELECTRIC DRIVE FOR PEDELECS
Incorrect handling leads to risk such as explosion, overheating
or fire. Failure to observe the instruction for use will lead to pre-
mature wear or other defects. Keep these instructions in a safe
place and be sure to include them if you give the battery to ano-
ther user.
After charging the battery, remove the power plug of the charger from the
mains outlet and disconnect the charging plug from the charging socket
of the battery. Close the cap on the charging socket again to prevent the
ingress of water and avoid corrosion.
The battery has a capacity indicator for checking the charge level. This is
done briefly pressing the button on the capacity indicator. Then the charge
level is displayed for a short time with LEDs. In driving mode the battery
level can be read from the display at the handlebar.

12. WIRING

As the central unit of the electric drive is defined, the motor controller.
At this control unit the components motor, display, brake levers and pe-
dal sensor have to be connected according to the following connection
diagram. As all plugs have different shape / size, incorrect connection of
these components is largely excluded. Only the wires of the motor cable
should be connected according to colors correctly to the motor controller.
It is essential to ensure tightness of connections to prevent malfunctions
due to lack of contact. The control unit and the cable over lengths are
then stowed in the controller box. Optional can be connected to terminal
L3 (POWER) a light module.
40
If a throttle grip is used, an additional electronic control unit must be
installed between the controller/display/throttle grip.
www.ansmann.de
41