Using The Battery / Charger - ANSMANN FM6.0 Originalbetriebsanleitung

ORIGINAL OPERATING INSTRUCTIONS - ELECTRIC DRIVE FOR PEDELECS
10.
HOLDER FOR THE CARRIER BATTERY
The holder (battery case) for the flat battery and the box for the motor
controller is factory-equipped assembled with the carrier. At the battery
case the connecting cable for the connection to the motor controller is
already assembled. The carrier should be assembled to the bicycle at its
defined positions.
box for the
motorcontroller
assembling points
for the frame
connection for
the battery

11. USING THE BATTERY / CHARGER

Charge the battery completely before the first use! The battery can be
charged either on or detached from the bicycle. A lock helps keep the bat-
tery fastened to the bicycle. To remove the battery from the bicycle, first
open the lock. At the down tube battery open the lock by turning the key
clockwise (1.), then push the battery out of its holder (2.). When assembling
the battery to the bicycle, the battery locks on its own (theft deterrence)
as soon as the battery is pushed completely onto the holder (the key is not
needed to lock it).
36
To
battery case ging socket (4) and connect the plug (5) from the charger.
lock for the battery
assembling points
for the frame
To remove the carrier battery from the bicycle, first open the lock by turing
the key counterclockwise (1.), then push the battery out of its case (2.).
After the battery is assembled into the case again it need to be locked with
the key (turning the key clockwise) that the battery could not fall out during
riding (also for theft deterrence).
2
charge the battery, open the
3
5
4
www.ansmann.de
1
cap (3) on the char-
37