End Of Program; Electricity Consumption And Recharging; Problems And Solutions - Compex Mi-FITNESS Gebrauchshandbuch

End of program

12a
12c
Fig. 12
12b
12a
12c
Fig. 12
12a At the end of the session, you hear a musical
signal, and a small flag is displayed.
12b The simultaneous presence of a flag and the
symbol skip means that you have skipped one or
several sequence(s) of the program. You have
therefore changed the program being used.
Depending on the programs, the displayed infor-
mation may differ. In some cases, it may also
happen that no information is displayed.
11a The mention "MAX" indicates by channel the
maximum energy level reached during contraction
phases (fig. 11).
11b The mention "AVG" indicates the average
energy level on all the channels used during the
contraction phases (fig. 11).
11c The m— 6 function, represented by a
bracket, indicates the percentage of the stimulation
time in the ideal energy adjustment range (fig. 11).
12c It is then only necessary to switch off the
stimulator by pressing the "On/Off" key (
8. Electricity consumption
and recharging
Never recharge the stimulator with
cables still connected to it. Never
recharge the batteries with a charger
different from the one supplied by Compex.
114
Downloaded from www.Manualslib.com
he Compex runs on rechargeable
T
batteries. The discharge time depends
on the programs and stimulation
energy used.
efore using your stimulator for the
B
first time, it is always strongly recom-
mended that you completely charge
the battery to improve its autonomy
and extend its working life. If you do
not use your device for a long period
of time, please regularly recharge the
battery.
Electricity consumption
he symbol of a small battery indicates
T
the charge level of the batteries.
13a
Fig. 13
13a The small battery symbol has only two
reference marks: The batteries are losing their
charge. Interrupt the session and recharge the
device (see the following section).
13b The symbol normally displayed above
START
the "+"/"–" key of channel 4 has disappeared
( ) and the small battery flashes: The batteries
are completely flat. It is no longer possible to use
the device. Recharge it immediately (see the
following section).
Recharging
o recharge the Compex, first discon-
T
OFF ).
nect the electrode cables from the
device, then plug the charger in a
socket and lastly connect the stimula-
tor to the charger. The charge menu
illustrated below appears automatically.
manuals search engine
14a
Fig. 14
14a The Compex has been charging for 3 minutes
and 8 seconds (a full charge may take from 1h00
to 1h30 hours with the rapid charger delivered
with your device).
14b Charging is in progress and the small battery
symbol is not completely full. When charging is
completed, total charge duration flashes and the
small battery is completely full. The Compex swit-
ches off automatically as soon as you disconnect
the charger.

9. Problems and solutions

Electrode fault
13b
Fig. 15
15-14a The Compex "bleeps" and alternatively
displays the symbol of a couple of electrodes and
an arrow pointing to the channel where a problem
has been detected. Below, the stimulator has
detected an electrode fault on channel 2. This
message may mean that:
1) there is no electrode connected to this channel;
2) the electrodes are old, worn out and/or the
contact is poor: try using new electrodes;
3) the electrode cable is defective: try it using
another channel. If cable shows a default again,
please replace.
Recharging error
recharging error may happen during
A
charging. The Compex "bleeps" conti-
14b
nuously and the following screen is
displayed:
Fig. 16
f this message appears, disconnect
I
the charger and the device switches
off automatically. Please contact the
hotline, noting this error code.
f, for any reason, you experience any
I
other trouble with your device, please
contact the hotline mentioned and
approved by Compex Médical SA.
15a
115