Denon DHT-M330DV Bedienungsanleitung Seite 31

4 Start playback on the selected component.
• For operating instructions, refer to the component's
manual.
5 Either turn the MASTER VOLUME dial on the main unit or
use the VOLUME buttons on the remote control unit to
adjust the volume.
D I I T G A L D V
Main unit
• The volume can be adjusted within the range 0 to 60. Note
that depending on the input signal, surround mode, speaker
settings and channel level setting, it may not be possible to
adjust the volume up to 60.
2 To check the currently playing program source, etc.
Press the MENU/SET button. Display "STATUS" then press
the select 0 and 1 control.
Main unit
The current program source and surround settings are shown
on the display each time the button is pressed or turned.
The volume level is
D
displayed on the
display.
+
-
Remote control unit
Main unit
Input mode display
• In the AUTO mode
Lit
• In the DIGITAL PCM mode
• In the DIGITAL DTS mode
• In the ANALOG mode
Input signal display
• DOLBY DIGITAL
• DTS
• PCM
• "DIG" lights when digital signals are input properly. If "DIG" is
flashing, check whether the connections are proper and whether
the input component's power is on.
Input mode when playing CD sources
• When playing CDs containing recordings of live concerts, etc., in
the "AUTO" mode, the sound may be slightly broken at the
beginning. If this happens, switch to the "PCM" mode.
Input mode when playing DTS sources
• If DTS-compatible CDs are played in the "PCM" mode, noise is
output because DTS playback is not possible.
To play a DTS-compatible source, be sure to set the input mode
to "AUTO" or "DTS".
• Noise may be generated at the beginning of playback and while
searching during DTS playback in the AUTO mode. If so, play in
the DTS mode.
ENGLISH
One of these lights, depending on
the input signal.
31