Function Of The Ice Maker; Using The Ice Maker - hanseatic HSBS17990WEHEBK Gebrauchsanleitung

Page EN-26 Removing cold water and ice
2. Push the vessel against the dispenser
guide (35).
Cold water will begin to pour into the ves-
sel.
3. Remove the vessel from the dispenser
guide to stop the flow of water.

Function of the ice maker

When the freezer has reached the set tem-
perature, water runs into the ice tray and the
chambers, freezing into ice cubes. This pro-
duces about 10 ice cubes at a time. When
the ice cubes are finished (i.e. when the wa-
ter is frozen), the ice tray will tilt and the ice
cubes will fall into the ice cube container. This
process repeats about 12–13 times a day.
When the ice cube container is full, no fresh
ice cubes are produced.
After the first time the appliance is operated, it
takes about 6 hours until ice cubes are avail-
able.
In order to produce crushed ice, the ice cubes
are chopped into chunks of only a few milli-
metres. This occurs within a grinding mech-
anism located inside the ice cube container.
Cold water, crushed ice and ice cubes pass
through the ice dispenser and are dispensed
via the ice outlet.

Using the ice maker

The production of ice cubes and crushed ice
creates noise. The water vent hums. Water
flows into the ice tray. The grinding mecha-
nism grinds ice cubes. Finished ice cubes fall
(35)
into the ice cube container. These noises are
normal.
When ice cubes are dispensed, there may be
loud cracking noises. This is also not a cause
for concern.
It is possible that ice cubes have stuck to-
gether in the ice cube container (4). In this
case:
1. Remove the ice maker.
2. Divide the fused ice cubes, for example
by carefully pushing on them with a plas-
tic or wooden spoon.
3. Remove ice cube clumps.
4. Divide the ice cubes evenly in the ice
cube container.
Other options are described in section "Clean-
ing the ice cube container" on page EN-31.
In order to avoid overheating the ice maker's
motor, the dispensing of ice will stop after
about 1 minute. In this case, wait a moment
until the motor has returned to operating tem-
perature. If you need a larger quantity of ice
cubes, take them directly from the ice cube
container instead. Section "Cleaning the ice
cube container" on page EN-31 describes how
to remove the ice cube container from the
freezer.
If there are not enough ice cubes in the ice
cube container, it may not be possible to dis-
pense any ice. If this is the case, please wait
until fresh ice cubes are produced.
In order to prevent unpleasant odours or fla-
vours from developing in the ice cubes, clean
the ice cube container on a regular basis.