Cleaning And Care - Honeywell SH-771E Gebrauchsanweisung

Pilot Light
1. The Pilot Light (8) will only illuminate when
the quick heater is in operation.
Overheating shut-off
1. This quick heater is equipped with an over-
heating shut-off. It automatically shuts off
the quick heater in case of overheating.
2. If such case occurs the Pilot Light (8)
remains illuminated, although the quick
heater does not operate. Turn the Power
Switch (7) to the off-position (10) and
disconnect the appliance from the electricity
supply.
3. Let the quick heater cool down for at least
15 – 20 minutes.
4. Remove any obstructions from the Air Inlet
(14) or Outlet (6) that may have caused
or overheating.
5. To operate the quick heater again, follow
the instructions under "Operating
Instructions".

CLEANING AND CARE

We recommend to clean the quick heater
frequently. In order to not impair the
performance of the quick heater, follow the
instructions for Cleaning and Care.
Cleaning
1. Before cleaning, turn the Power Switch (7)
to the off-position (10) and unplug the unit.
2. Clean the Air Inlet (14) and Outlet (6) with
a vacuum cleaner to remove dust from the
motor and the heating element.
3. Use a soft, damp cloth to wipe the external
surfaces.
4. To operate the quick heater follow the
instructions under „Operating Instructions"
ENGLISH
Care
1. This quick heater does not require any
special care.
2. In case the quick heater must be repaired,
contact an authorised specialist.
3. If the Supply Cord (15) must be repaired,
only a type 2*1 mm
must be used.
CONDITION OF SALE
As a condition of sale, the purchaser assumes
responsibility for the proper use and care of this
appliance in accordance with these printed
instructions. The purchaser or user must judge
himself or herself when to use the appliance and
the length or use.
NOTE: IF YOU EXPERIENCE A PROBLEM
WITH YOUR QUICK HEATER PLEASE SEE
WARRANTY FOR INSTRUCTIONS. PLEASE
DO NOT ATTEMPT TO REPAIR THE QUICK
HEATER YOURSELF. DOING SO WILL
VOID THE WARRANTY AND COULD
CAUSE DAMAGE OR PERSONAL INJURY.
Technical specifications are subject to change.
6
H05VVF HAR Cord
2