Important Safety Instructions; Parts Identification - Honeywell SH-771E Gebrauchsanweisung

IMPORTANT SAFETY INSTRUCTIONS

Read all instructions before operating this quick
heater. Keep these instructions.
1. Operate the quick heater out of the reach of
children.
2. Do not operate the quick heater outdoors.
3. Place the quick heater on a level, firm surface.
Make sure it is in a stable position, so that it
cannot fall over or fall down. Only operate
the quick heater in an upright position.
4. Unravel the Supply Cord (15) before use.
Failure to do so could cause overheating
and possible fire hazard.
5. Do not use an extension cord or a
solid-state speed-control device. Doing so
could cause overheating, fire hazard or
electric shock.
6. Only connect the quick heater to a
single-phase AC supply to the voltage
shown on the rating plate.
7. Always disconnect cord at wall plug before
removing the quick heater, touching,
moving, cleaning or when not in use.
Do not pull on Supply Cord (15) when
disconnecting it.
Do not operate the quick heater in rooms
8.
with explosive gases or while using
inflammable solvents, varnish, glue etc.
9. Do not place the quick heater directly below
a socket.
10. Do not use this quick heater in the
immediate surroundings of a bath, shower
or swimming pool.
11. This quick heater must not be used in any
kind of vehicle (e.g. builder's huts, lifts,
camper vans, motor vehicles, cars) and
similar, self-contained space.
12. If wall-mounted do not fix to combustible
material such as wooden, synthetic or
plastic surfaces.
13. Caution: The Air Outlet (6) gets hot during
operation (above 80 °C or 175 °F). Keep
combustible material such as furniture,
cushions, bedding, paper, curtains, clothes
at least 1 meter away from the quick heater.
14. Keep the quick heater clean. Make sure that
the Air Inlet (14) and Outlet (6) are
unobstructed. Do not allow any objects to
enter into the Air Inlet (14) and Outlet (6).
Do not cover the quick heater. This could
cause overheating, fire hazard or electric
shock.
ENGLISH
15. Do not immerse the quick heater in water or
other liquids and do not pour water or other
liquids over the appliance or into the Air
Inlet (14) or Outlet (6).
16. Clean the quick heater regularly and follow
the "Cleaning Instructions".
17. If the Supply Cord (15) of the quick heater
is damaged it must be repaired by a repair
shop appointed by the manufacturer, as
special purpose tools are required.
18. Do not operate the quick heater if it is
damaged, faulty or is not working properly.
Disconnect it from the electricity supply.

PARTS IDENTIFICATION

1. Opening for Wall-Mounting Support
2. Wall-Mounting Support
3. Installation Zones
4. Safety Distances
5. Variable Air Flow Range
6. Air Outlet
7. Power Switch
8. Pilot Light
9. Thermostat Switch
10. Off-Position
11. Warm Air 1000 W Low Speed
12. Warm Air 1200 W Low Speed
13. Hot Air 2000 W High Speed
14. Air Inlet
15. Supply Cord with plug
16. Cord Storage
17. Room Temperature approx. 5 °C
18. Room Temperature approx. 30 °C
OPERATION
First Time Use
1. Read all instructions before using the quick
heater.
2. Unpack the quick heater and the Supply
Cord (15); remove all packaging material
and discard. Packaging material can be
recycled.
3. Place the quick heater on a level, firm
surface. Make sure it is in a stable
position, so that it cannot fall over or fall
down. A safety distance of at least 40 cm
from any objects must be kept.
4