Monacor TVCAM-110BF Anleitung Seite 2

TVCAM-110BF
Order number 18.8810
ELECTRONICS FOR SPECIALISTS ELECTRONICS FOR SPECIALISTS ELECTRONICS FOR SPECIALISTS ELECTRONICS FOR SPECIALISTS ELECTRONICS FOR SPECIALISTS ELECTRONICS
HD-TVI Colour Camera
These instructions are intended for
installers of video surveillance systems.
Please read these instructions carefully
prior to installing the camera and keep
them for later reference.
1 Applications
This colour camera is especially designed for
video surveillance systems (CCTV). Featu-
ring HD-TVI technology (High Definition
Transport Video Interface), the camera sup-
ports the transmission of high-resolution ana-
log video signals (1080p) via standard coa-
xial cables with a length of up to 300 m. Due
to its robust metal housing, the camera is
weather-proof (IP 66) and is therefore also
suitable for outdoor applications. Camera
features include: automatic white balance,
digital noise suppression and automatic gain
control. When darkness falls, the IR LEDs
will illuminate a surveillance area of up to
30 m, the IR filter will be deactivated and the
camera will switch to B / W mode.
2 Important Notes
The camera corresponds to all relevant
directives of the EU and is therefore marked
with .
G
Protect the camera against extreme tem-
peratures (admissible ambient tempera-
ture range: −10 °C to +50 °C).
G
Do not use aggressive detergents or che-
micals for cleaning the camera.
G
No guarantee claims for the camera and no
liability for any resulting personal damage
or material damage will be accepted if the
camera is used for other purposes than ori-
ginally intended, if it is not correctly instal-
led, or if it is not repaired in an expert way.
If the camera is to be put out of ope-
ration definitively, take it to a local re-
cycling plant for a disposal which is
not harmful to the environment.
3 Installation
1) Make a test run to determine the optimum
mounting location.
2) At the mounting location (e. g. wall or ceil -
ing), drill three holes for fixing the base (4)
and, if necessary, drill a hole for the con-
nection cable (alternatively, the cable can
be guided through one of the cable inlets at
the side of the base). Fasten the base at
the mounting location. If required, loosen
the nut (3) of the camera support.
3) Connect the BNC inline jack (6) to the input
of an HD-TVI compatible video recorder
(e. g. from the TVR series from MONACOR).
4) Connect a regulated 12 V power supply
unit with a permanent rating of 450 mA to
the inline jack (7). A low-voltage plug
5.5/2.1 mm (exterior/ interior diameter) is
required. Make absolutely sure to observe
the correct polarity (centre contact = +).
CAUTION The infrared LEDs will switch
on when darkness falls. When setting up
the camera, never look directly into the lit
infrared LEDs from a close range. The
infrared light may cause eye irritation.
However, the infrared radiation is far
below the emission limit and rated risk-
free according to EN 62471.
5) Please observe the following for outdoor
installations:
The connections (6, 7) and the cable split-
ter (5) are not weather-proof and must be
protected accordingly.
6) Switch on the video recorder and the moni-
tor connected and align the camera by
means of the monitor image: Loosen the
nut (3) and position the camera as desired.
Then retighten the nut.
7) To protect the lens against direct sunlight,
position the sunshield (1) on the camera
and fasten it with the locking screw (2).
®
MONACOR INTERNATIONAL GmbH & Co. KG • Zum Falsch 36 • 28307 Bremen • Germany
Copyright © by MONACOR INTERNATIONAL. All rights reserved.
4 Specifications
Image sensor: . . . . . . . . . . CMOS chip,
Number of pixels: . . . . . . . 1920 × 1080
Resolution: . . . . . . . . . . . . 1080p / 25
Colour modulation system: PAL
Lens: . . . . . . . . . . . . . . . . . 3.6 mm/1 : 1.2
Electronic shutter: . . . . . . .
Video output: . . . . . . . . . . 1 Vpp / 75 Ω
IR LEDs, range: . . . . . . . . 42 LEDs, 30 m
Power supply: . . . . . . . . . 12 V ±10 %,
Ambient temperature: . . . . −10 °C to +50 °C
Protection: . . . . . . . . . . . . IP 66
Dimensions: . . . . . . . . . . . ∅ 87 × 219 mm
Weight: . . . . . . . . . . . . . . . 250 g
Subject to technical modification.
A-1648.99.01.03.2015
8.5 mm (⅟ ³ ")
1 ⁄ – 1 ⁄ s
50 67 500
450 mA