Mercedes-Benz Seat covers Montageanleitung Seite 8

7
3
2. Open the seat belt loop (6) and place the seat belt
to the side.
3. Slip the seat cover (3) over the head restraint (7),
pull the rear downwards carefully between the seat
backrest shell and the head restraint (7) until the seam
of the seat cover (3) is resting against the edge (arrows)
of the seat backrest shell; then pull the front
downwards until it is underneath the head restraint (7).
4. Grip the seat belt loop (6) under the seat cover (3)
and guide it through the lower slot in the seat cover (3).
5. Slip the seat cover (3) over the contour of the seat
backrest and straighten it.
7
6
3
6. Push the Velcro fastener (8) through between the
seat backrest and the seat cushion, and fasten the
Velcro fastener (8) on the inside of the seat cover (3).
Important
The seat belt must always be guided through the
seat belt loop, and the seat belt loop must always
be closed.
7. Place the seat belt in the seat belt loop (6), guide the
seat belt loop (6) through the upper slot in the seat
cover (3), and close the seat belt loop (6).
- 5 -
3
6
3
8
M+P-03F-5305