Inhaltsverzeichnis
Werbung
CONNECTIONS - Transmitter
(F) Connexions (D) Anschlüsse (I) Collegamenti (ES) Conexiones (P) Ligações (NL) Aansluitingen (DK) Forbindelser (CN)
Connecting the transmitter unit
1. Set the Subwoofer Mode to wireless
2. Connect the subwoofer to the mains supply and turn the subwoofer
on.
3. Power off all A/V equipment during the installation of the wireless
system.
4. Connect the supplied AC-DC adaptor to the DC jack socket on the
rear panel of the transmitter unit.
5. Connect the RCA cable from the amplifier subwoofer out to the
signal input jack on the transmitter.
6. Rotate the position of the transmitter unit such that the front panel
is facing toward the subwoofer.
7. Connect the AC-DC adaptor to the mains supply and turn on the
transmitter.
8. Ensure the blue bonding light is permanently on, this shows the
transmitter unit and the subwoofer are successfully bonded and
ready to output audio. If the bonding light is flashing ensure that both
units are on and within range.
连接
DC INPUT
11
Werbung
Inhaltsverzeichnis
