Herunterladen Inhalt Inhalt Diese Seite drucken

Connecting A Power Source; To Use The Ac Power Adapter And Dc Cable; To Select The Camcorder Mode (Vp-D463(B)(I)/D467(I) Only); Stromversorgung Herstellen - Samsung VP-D461 Bedienungsanleitung

Digitaler camcorder
Inhaltsverzeichnis

Werbung

ENGLISH
Preparation

Connecting a Power Source

There are two types of power source that can be connected to your Camcorder.
- The AC Power adapter and AC Cord: used for indoor recording.
- The Battery pack: used for outdoor recording.

To use the AC Power Adapter and DC Cable

1. Connect the AC Power adapter to the AC Cord.
2. Connect the AC Cord to a wall socket.
[ Notes ]
You must use an AA-E8 TYPE AC Power
I
adapter.
The plug and wall socket type may differ
I
according to your resident country.
3. Connect the DC cable to the DC jack socket of
the Camcorder.
4. Set the Camcorder to each mode by holding
down the tab on the Power switch and turning
it to the CAMERA or PLAYER mode.

To Select the Camcorder Mode (VP-D463(B)(i)/D467(i) only)

If you want to use this unit as a Camcorder, set the
Mode switch to TAPE.
If you want to use this unit as a DSC (Digital Still
Camera), set the Mode switch to MEMORY.
20
20
Vorbereitung

Stromversorgung herstellen

Der Camcorder kann auf zwei Arten mit Strom versorgt werden:
- Für Innenaufnahmen können Sie den Camcorder über das Netzteil und das
Netzkabel an eine Steckdose anschließen.
- Für Außenaufnahmen können Sie den Akku verwenden.
Netzteil und Gleichstromkabel anschließen
Power Switch
<CAMERA mode>
<PLAYER mode>
Gerät als Camcorder oder Digitalkamera verwenden
(nur VP-D463(B)(i)/D467(i))
1. Verbinden Sie das Netzkabel mit dem
Netzteil.
2. Schließen Sie das Netzkabel an eine
Steckdose an.
[ Hinweise ]
Verwenden Sie ein Netzteil des Typs
I
AA-E8.
Stecker und Steckdose können sich
I
von Land zu Land unterscheiden.
3. Verbinden Sie das Gleichstromkabel des
Netzteils mit dem Gleichstromanschluss des
Camcorders.
4. Schalten Sie den Camcorder ein, indem Sie
den Power-Schalter herunterdrücken und
dann je nach gewünschtem Modus auf
CAMERA bzw. PLAYER stellen.
Wenn Sie das Gerät als Camcorder verwenden
möchten, stellen Sie den Funktionsschalter auf TAPE.
Wenn Sie das Gerät als Digitalkamera verwenden
möchten, stellen Sie den Funktionsschalter auf
MEMORY.
DEUTSCH

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis