Pkm KF4-2KB Bedienungsanleitung Seite 39

A(mm) B(mm) C(mm) D
760
Installation
(1) Before installing the hob, the adhesive seal has to be fixed on the bottom edge
of the hob properly.
 The seal has to be fixed properly. The outer side of the seal must match the
bottom outer edge of the hob (s. fig. below). The seal must be fitted tightly
on the bottom edge of the hob (no overlaps, no gaps etc.) to prevent liquids
etc. from entering the installation opening subsequently.
1. Seal
2. Hob
3. Worktop
4. Outer edge of the hob
5. Outer side of the seal
6. Bottom of the hob
50 min. 30 min. Air inlet Air outlet 5 mm
1
39
E
6