Gima SUPERVEGA EVO Handbuch Seite 22

Charging operations (through the supplied AC/DC adapter): To charge the internal battery, connect the
universal adaptor (supplied) to the mains electricity supply for about 6 hours (360 minutes) with the device
switched off (not operating).
The symbol positioned near the 12V jack on the casing requires the user to read the instructions before
each use, identifying the model and type of power supply which can be connected through the information
provided in the instructions for use.
LIGHT INDICATORS
The device is provided with a light indicator (directly on the LCD screen) which allows you to view the opera-
tion of the device, autonomy of the battery, and the charge phase in progress.
The light indications, which appear during operation, are indicated in table I.
The charge cycle starts automatically by placing the device on the specific support bracket (ref. Support
Bracket and Charge Chapter). The charge occurs only when the motor of the suction unit is off.
DISPLAY IN CHARGE: this is on with white back-light and it remains on for the entire time. It switches off if
there is no external voltage. The charge phase lasts until the device is powered and the battery is kept at its
maximum charge. The large digits display "CHA" .
TAB. I – INDICATOR LIGHTS DURING OPERATIONS
Back-light signals
Fixed white back-light
and progressive activa-
tion of the bar-graph
Fixed white back-light
and fixed activation of
the bargraph
Fixed green back-light
Fixed yellow back-light
Fixed red back-light
Flashing red back-light
TAB. II – WRITTEN SIGNALS / BUTTON LED SIGNAL
Button LED signal /
written signal
ON/OFF button
Proximity Button
CHA
Small three-digit
number (000)
Bar-graph
(arc bar-graph)
ENGLISH
Phase Problem / Cause
During the Charge Battery charge in
phase progress
During the Charge Charging cycle complete Remove the device from the
phase
During battery Primary status / Battery
operation fully charged
During battery Intermediate status /
operation Battery not fully charged
During battery Low battery
operation
Automatic switch-off Battery fully discharged
of the device due to
discharged battery
Function
Power on
Switch the ON/OFF key
Displays the battery
charge status
Displays the voltage of the
device if in charge phase
or it displays the full scale
of the bar-graph.
It displays the trend of the
negative pressure or of the
charge status
Solution
Wait
support plate of the ambulance
Battery operation guaranteed
Battery operation guaranteed / start the charge
cycle upon activation of the red back-light
Start charge phase
ATTENTION: A long and continuous beep is
produced during this signal to warn the opera-
tor about the low charge level of the battery.
The flashing back-light switches on upon
reactivation of the device. Immediately start
the battery charge cycle.
Colour
Green
Blue
Fixed white back-light and progres-
sive activation of the bargraph
Fixed white or green back-light
depending on whether external
power supply or battery and
progressive activation of the
bar-graph are used.
Progressive activation of the
bar-graph (black)
Position
Near the front panel key
LED located above
the "Proximity" key
Central in digits of large
dimensions
Sideways in small digits
Arc-shaped in the middle
of the screen
22