Weidmuller 10/120 Serie Betriebs- Und Wartungsanleitung Seite 28

Operating
5 Whenever several crimpings are necessary start crimping from the flange to the end
of the sleeve (see Figure 3).
You find the minimum amount of crimpings in the current Weidmüller crimp-
ing-instructions in chapter 4, Crimping instructions.
The crimping width of all cross-sections for these types of tool is 5 mm.
When processing connectors, the mentioned number of crimpings has to be dedicated
to each side of the connector.
Figure 3 Working direction for crimpings
28 1548670000/00/06.14